1 USB cable release lever
2 USB cable
There are release levers on the Ethernet and systems management connectors. To
disconnect a cable from one of these connectors, pull up on the lever to release the
cable.
1 Ethernet activity
LED
3 Ethernet speed LED
2 Ethernet port 4 Ethernet cable release lever
Updating the server configuration
When you start the server for the first time after you add or remove an internal
option or external device, you might receive a message that the configuration has
changed. The UEFI Setup Utility program starts automatically so that you can save
the new configuration settings.
Some options have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each option.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see
“Configuring the Gigabit Ethernet controllers” on page 138.
Chapter 5. Installing optional devices and replacing customer replaceable units 113
