removed. Before disconnecting the power source, make a note of which LEDs
are lit, including the LEDs that are lit on the operation information panel, the
EasyLED panel, and LEDs that are lit inside the server on the system board;
then, see the “EasyLED” on page 157 for information on how to solve the
problem.
3. Remove the cover (see “Removing and replacing the cover” on page 43).
4. Touch the static-protective package that contains the new ServeRAID-MR10i
SAS/SATA controller to any unpainted surface on the outside of the server; then,
grasp the adapter by the top edge or upper corners of the controller and remove
it from the package.
5. Align the ServeRAID-MR10i SAS/SATA controller so that the keys align correctly
with the connector on the SAS/SATA RAID riser card assembly.
6. Insert the SAS/SATA adapter into the connector on the SAS/SATA RAID
riser-card until it is firmly seated.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
1 USB embedded connector
2 RAID adapter connector
3 Riser card error LED
4 SAS/SATA RAID riser card
1 SAS/SATA RAID riser-card
2 ServeRAID-MR10i adapter
7. Tilt the SAS/SATA RAID riser-card assembly slightly and insert the end of the
adapter in the slot on the retention bracket as shown in the following illustration.
Make sure that the SAS/SATA RAID riser-card assembly keys align correctly
Chapter 5. Installing optional devices and replacing customer replaceable units 69
