v Take the battery retention clip and place it underneath the other tab while
pressing release tab toward the front of the server; then, press it down until it
snaps in place to hold the battery carrier firmly in place.
6. Install the cover (see “Removing and replacing the cover” on page 43).
7. Slide the server into the rack.
8. Reconnect the power cords and all external cables, and turn on the server and
peripheral devices.
Removing and installing the bezel
To remove and install the bezel, complete the steps in this section.
Removing the bezel
To remove the bezel, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the hard disk drives and filler panels from the hard disk drive bays (see
“Removing and installing a hot-swap hard disk drive” on page 50).
4. Remove the screws 1 from the bezel 2.
5. Remove the screws from the video connector 3.
6. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on
the bottom of the bezel disengages from the chassis and set it aside.
Installing the bezel
To install the bezel, complete the following steps:
1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
2. Rotate the bezel 2 upward to the server and reinstall the bezel screws 1.
108 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide
