Configuring and Managing IP Interfaces and Services 153
Nortel WLAN Security Switch 2300 Series Configuration Guide
23x0# show interface
* = From DHCP
VLAN Name Address Mask Enabled State RIB
---- --------------- --------------- --------------- ------- ----- --------
1 default 10.10.10.10 255.255.255.0 YES Up ipv4
2 roaming 10.20.10.10 255.255.255.0 YES Up ipv4
2 Configure the IP interface on the roaming VLAN to be the system IP address and verify the configuration
change. Type the following commands:
23x0# set system ip-address 10.20.10.10
success: change accepted.
23x0# show system
===============================================================================
Product Name: WSS-20
System Name: WSS-20
System Countrycode: US
System Location:
System Contact:
System IP: 10.02.10.10
System MAC: 00:0B:0E:00:04:0C
License: unlimited
===============================================================================
Boot Time: 2000-03-18 22:59:19
Uptime: 0 days 01:12:02
===============================================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok temp2 ok temp3 ok
PSU Status: Lower Power Supply DC ok AC ok Upper Power Supply missing
Memory: 156.08/496.04 (31%)
Total Power Over Ethernet : 105.6
===============================================================================
3 Configure a default route through a gateway router attached to the WSS switch and verify the
configuration change. Type the following commands:
23x0# set ip route default 10.20.10.1 1
success: change accepted.
23x0# show ip route
Router table for IPv4
Destination/Mask Proto Metric NH-Type Gateway VLAN:Interface
__________________ _______ ______ _______ _______________ _______________
0.0.0.0/ 0 Static 1 Router 10.20.10.1
10.10.10.10/24 IP 0 Direct vlan:1:ip
10.10.10.10/32 IP 0 Local vlan:1:ip:10.10.10.10/24
10.20.10.10/24 IP 0 Direct vlan:1:ip
10.20.10.10/32 IP 0 Local vlan:1:ip:10.20.10.10/24
224.0.0.0/ 4 IP 0 Local MULTICAST
4 Configure the DNS domain name and DNS server entries, enable the DNS service, and verify the
configuration changes. Type the following commands:
23x0# set ip dns domain example.com
success: change accepted.
23x0# set ip dns server 10.10.10.69 PRIMARY
