Appendix A: Troubleshooting a WS Switch 579
Nortel WLAN Security Switch 2300 Series Configuration Guide
SYS Jun 02 17:41:35. 176214 ERROR nos_vms_port?add: Failed to set default vlan
v1 an:4096 for port 3 rc 1
To filter the event log by WSS Software area, use the facility facility-name keyword. For a list of facilities for which you
can view event messages, type the following command:
23x0# show log buffer facility ?
<facility name> Select one of: KERNEL, AAA, SYSLOGD, ACL, APM,
ARP,ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY,
HTTPD, IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD,
SPAN, STORE, SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN,
X509, XML, AP, RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.
To clear the buffer, type the following command:
23x0# clear log buffer
To disable logging to the system buffer, type the following command:
23x0# set log buffer disable
Logging to the Console
By default, console logging is enabled and messages at the error level and higher are sent to the console.
To modify console logging, use the following command:
set log console severity severity-level
(See Table 38 on page 576 for information on severity levels.)
For example, to set logging to the console for events at the critical severity level and higher, type the following
command:
23x0# set log console severity critical
success: command accepted.
To disable console logging, type the following command:
23x0# set log console disable
success: change accepted.
The console is always available, but it has the following limitations:
• Console logging is slow.
• Messages logged to the console are dropped if the console output buffer overflows. WSS Software displays a
message indicating the number of messages dropped.
• If you type anything to the console, the typing disables log output to the console until you press the Enter key.
Logging Messages to a Syslog Server
To send event messages to a syslog server, use the following command:
set log server ip-addr severity severity-level [local-facility facility-name] enable
