35
Nortel WLAN Security Switch 2300 Series Configuration Guide
Using the Command-Line
Interface
WLAN 2300 System Software (WSS Software) operates a Nortel WLAN 2300 System wireless LAN (WLAN)
consisting of WLAN Management Software software, WLAN—Security Switch (WSS) switches, and Access Point
(AP) access points. WSS Software has a command-line interface (CLI) on the WSS switch that you can use to configure
and manage the switch and its attached AP access points.
You configure the WSS and AP access points primarily with set, clear, and show commands. Use set commands to
change parameters. Use clear commands to reset parameters to their defaults. In many cases, you can overwrite a
parameter with another set command. Use show commands to display the current configuration and monitor the status
of network operations.
The WSS supports two connection modes:
• Administrative access mode, which enables the network administrator to connect to the WSS and configure the
network
• Network access mode, which enables network users to connect through the WSS to access the network
CLI Conventions
Be aware of the following WSS Software CLI conventions for command entry:
• “Command Prompts” on page 36
• “Syntax Notation” on page 37
• “Text Entry Conventions and Allowed Characters” on page 38
• “User Wildcards, MAC Address Wildcards, and VLAN Wildcards” on page 39
• “Port Lists” on page 41
• “Virtual LAN Identification” on page 42
CLI Conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Command-Line Editing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
Using CLI Help . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
Understanding Command Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50
