A SERVICE OF

logo

Open as PDF
next previous
Configuring AAA for Administrative and Local Access 67
Nortel WLAN Security Switch 2300 Series Configuration Guide
Local Authentication
The first time you access an WSS switch, it requires no authentication. (For more information, see “First-Time Configu-
ration using the Console” on page 56.) In this scenario, after the initial configuration of the WSS switch, Natasha is
connected through the console and has enabled access.
To enable local authentication for a console user, you must configure a local username. Natasha types the following
commands in this order:
23x0# set user natasha password m@Jor
User natasha created
23x0# set authentication console * local
success: change accepted.
23x0# save config
success: configuration saved.