Configuring AP access points 247
Nortel WLAN Security Switch 2300 Series Configuration Guide
Configuring AP access points
To configure AP access points, perform the following tasks, in this order:
• Specify the country of operation. (See “Specifying the Country of Operation” on page 248.)
• Configure a template for automatic configuration of Distributed APs. (See “Configuring a Template for Automatic
AP Configuration” on page 251.)
• Configure AP access points and dual homing. (See “Configuring AP Port Parameters” on page 256.)
• Configure AP-WSS security. (See “Configuring AP-WSS Security” on page 261.)
• Configure a service profile to set SSID and encryption parameters. (See “Configuring a Service Profile” on
page 265.)
• Configure a radio profile. (See “Configuring a Radio Profile” on page 267.)
• If required, configure the channel, transmit power, and external antenna type on each radio. (See “Configuring
Radio-Specific Parameters” on page 273.)
• Map the radio profile to a service profile. (See “Mapping the Radio Profile to Service Profiles” on page 276.)
• Assign the radio profile to radios and enable the radios. (See “Assigning a Radio Profile and Enabling Radios” on
page 277.)
