88 Configuring and Managing Ports and VLANs
320657-A
To verify the configuration change, type the following command:
23x0# show vlan config
Admin VLAN Tunl Port
VLAN Name Status State Affin Port Tag State
---- ---------------- ------ ----- ----- ---------------- ----- -----
1 default Up Up 5
server2noneUp
To indicate that the ports are configured as a port group, the show vlan config output lists the port group name
instead of the individual port numbers.
Removing a Port Group
To remove a port group, use the following command:
clear port-group name name
Displaying Port Group Information
To display port group information, use the following command:
show port-group [all | name group-name]
To display the configuration and status of port group server2, type the following command:
23x0# show port-group name server2
Port group: server2 is up
Ports: 15, 17
Interoperating with Cisco Systems EtherChannel
Load-sharing port groups are interoperable with Cisco Systems EtherChannel capabilities. To configure a
Cisco Catalyst
switch to interoperate with a Nortel WSS, use the following command on the Catalyst switch:
set port channel port-list mode on
Configuring and Managing VLANs
Note. The CLI commands in this chapter configure VLANs on WSS network ports. The
commands do not configure VLAN membership for wireless or wired authentication users.
To assign a user to a VLAN, configure the RADIUS Tunnel-Private-Group-ID attribute or
the VLAN-Name vendor specific attribute (VSA) for that user. (For more information, see
“Configuring AAA for Network Users,” on page 401.)
