Configuring and Managing Mobility Domain Roaming 183
Nortel WLAN Security Switch 2300 Series Configuration Guide
Clearing a Mobility Domain Member from a Seed
You can remove individual members from the Mobility Domain on the seed WSS. To remove a specific member of the
Mobility Domain, type the following command:
clear mobility-domain member ip-addr
This command has no effect if the WSS member is not configured as part of a Mobility Domain or the current WSS is
not the seed.
Monitoring the VLANs and Tunnels in a Mobility Domain
Tunnels connect WSSs. Tunnels are formed automatically in a Mobility Domain to extend a VLAN to the WSS that a
roaming station is associated with. A single tunnel can carry traffic for many users and many VLANs. The tunnel port
can carry traffic for multiple VLANs by means of multiple virtual ports.
WSS Software automatically adds virtual ports to VLANs as needed to preserve the associations of users to the correct
subnet or broadcast domain as they roam across the Mobility Domain. Although tunnels are formed by IP between
WSSs, the tunnels can carry user traffic of any protocol type.
WSS Software provides the following commands to display the roaming and tunneling of users within their Mobility
Domain groups:
• show roaming station (See “Displaying Roaming Stations” on page 184.)
• show roaming vlan (See “Displaying Roaming VLANs and Their Affinities” on page 185.)
• show tunnel (See “Displaying Tunnel Information” on page 186.)
