A SERVICE OF

logo

_______________________________________ Ethernet Setup 5-27
2. Choose Networking: TCP/IP: Address.
Fig. 5.21 Macintosh TCP/IP Address Control Window
3. Change the printer’s default TCP/IP address to the address
assigned by your System Supervisor, using the tab key to move
to the next octet.
4. Click Ok. Command Center’s main menu reappears.
5. If necessary, enable the printer’s Line Printer interface. The
Line Printer interface is enabled as the factory default.
a. Choose Networking: TCP/IP: LPR Enable.
Fig. 5.22 Macintosh LPR Communications Control Window
b. Click the option buttons to enable (ON) or disable (OFF)
the Line Printer interface on your printer.
c. Click Ok. The main menu reappears.