_____________________________________ Troubleshooting 11-7
• Make sure the Macintosh is setup to communicate using
LocalTalk. See “Connecting to the LocalTalk Port” in
chapter 2.
• Make sure the correct Adobe PostScript printer driver and
your printer’s PPD are installed and configured properly.
See “Adobe PostScript Printer Drivers” in chapter 3.
• Make sure the correct Adobe PostScript printer driver and
your printer are selected in the Chooser. See “Adobe
PostScript Printer Drivers” in chapter 3.
• Make sure the AppleTalk button is active in the Chooser.
• Make sure the LocalTalk port is enabled on the printer.
See “Interface Control” in chapter 6.
• Make sure the printer is on line. See “Interface Control” in
chapter 6.
• Make sure you install screen fonts to match the printer fonts
you use. See “XANTÉ Utilities CD-ROM” in chapter 3.
My printer does not respond properly to my PC using a parallel
connection.
• Make sure all cables are connected and seated properly.
See “Connecting to the Parallel Port” in chapter 2.
• Make sure the correct Adobe PostScript printer driver and
your printer’s PPD are installed and configured properly.
See “Adobe PostScript Printer Drivers” in chapter 4.
• Make sure the parallel port is enabled on the printer. See
“Interface Control” in chapter 6.
Note: If printing binary data, make sure the parallel
mode is set to PS TBCP.
• Make sure the printer is on line. See “Interface Control” in
chapter 6.
• Make sure the previous job has been cleared from the
printer by sending an end-of-job marker using the D.PS
file. See “PS_Files Folder” in chapter 4.
