11-6 Troubleshootingbb____________________________________
Power and Setup Issues
This section provides tips for resolving problems concerning power
to the printer and host or concerning printer setup.
My printer has no power.
• Make sure the power cord is plugged into the printer and
the power source. See “Connecting the Power Cord” in
chapter 2.
• Make sure the printer is turned on. See “Turning the
Printer On” in chapter 2.
• Make sure the power source is grounded, working, and
rated for 100 V, 15 A.
The printer has power but no start-up page prints.
• Make sure the start-up page feature is enabled. See
“Start-up Page” in chapter 6.
• Check the front panel window for a status message. See
“Status Messages” in this chapter.
• Make sure the toner cartridge is installed properly. See
“Toner Cartridge” in chapter 2.
• Make sure there is paper in the selected tray. If you are
using a paper cassette, make sure it is installed properly.
See “Paper Cassette” and “Multipurpose Feeder” in
chapter 2.
My printer does not respond properly to my Macintosh using a
LocalTalk connection.
• Make sure all cables are connected and seated properly.
See “Connecting to the LocalTalk Port” in chapter 2.
• Make sure both ends of the LocalTalk network have
terminating resistors installed. See “Connecting to the
LocalTalk Port” in chapter 2.
