Filter
Top Products
22 3Com Switch 4200G Family
Command Reference
interface
Use the command interface command to enter Ethernet port view. To configure parameters for a port, you
must enter the port view first.
System view
interface VLAN-interface
Use the interface vlan-interface command to create a management VLAN interface and enter
management VLAN interface view.
System view
Web command: Device -> VLAN Interface
Administration -> IP Setup
ip address
Use the ip address command to assign an IP address (and mask) to a management VLAN interface.
VLAN Interface view
Web command: Administration -> IP Setup -> Device -> VLAN
ip address bootp-alloc
Use the ip address bootp-alloc command to configure VLAN interface to obtain IP address using
BOOTP.
VLAN Interface view
ip address dhcp-alloc
Use the ip address dhcp-alloc command to configure VLAN interface to obtain an IP address using
DHCP.
VLAN Interface view
ip host
Use the ip host command to configure a host name and the corresponding IP address for a switch.
System view
ip http acl
Use the ip http acl command to apply an ACL to filter Web users.
System view
User Interface view
ip-pool
Use the ip-pool command to configure a private IP address range for cluster members on the switch to
be set as the management device.
Cluster view
ip route-static
Use the ip route-static command to configure a static route.
Use the
ip route-static command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
Web command: Device -> IP Route
ip route-static
Use the ip route-static command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
key
Use the key command to specify a shared key for the RADIUS authentication/authorization packets or
accounting packets.
RADIUS Scheme view
Web command: Security -> RADIUS Client
lacp enable
Use the lacp enable command to enable the LACP protocol on the current port.
Ethernet Port view
Web command: Port -> LACP
lacp port-priority
Use the lacp port priority command to configure port priority value.
Ethernet Port view
lacp system-priority
Use the lacp system-priority command to configure system priority value.
System view
Web command: Port -> LACP