Filter
Top Products
28 3Com Switch 4200G Family
Command Reference
port hybrid pvid vlan
Use the port hybrid pvid vlan command to configure the default VLAN ID of the hybrid port.
Ethernet Port view
port hybrid vlan
Use the port hybrid vlan command to add the port to the specified VLAN(s). The port needs to have been
made a hybrid port before you can do this. See the related command below.
Ethernet Port view
port isolate
Use the port isolate command to add an Ethernet port to the isolation group.
Ethernet Port view
port link-aggregation group
Use the port link-aggregation group agg_id command to add an Ethernet port to a manual or static
aggregation group.
Ethernet Port view
port link-type
Use the port link-type command to configure the link type of the Ethernet port.
Ethernet Port view
port-security enable
Use the port-security enable command to enable port security.
System view
port-security intrusion-mode
Use the port-security intrusion-mode command to set the action mode of the Intrusion Protection
feature.
Ethernet Port view
port-security max-mac-count
Use the port-security max-mac-count command to set the maximum number of MAC addresses allowed
to access the port.
Ethernet Port view
port-security ntk-mode
Use the port-security ntk-mode command to set the packet transmission mode of the Need to Know
(NTK) feature.
Ethernet Port view
port-security OUI
Use the port-security OUI command to set an OUI value for authentication.
System view
port-security port-mode
Use the port-security port-mode command to set the security mode of the port.
Ethernet Port view
port-security timer disableport
Use the port-security timer disableport command to set the time during which the system temporarily
disables a port.
System view
port-security trap
Use the port-security trap command to enable the sending of the specified type(s) of trap messages.
System view
port trunk pvid vlan
Use the port trunk pvid vlan command to configure the default VLAN ID for a trunk port.
Ethernet Port view
port trunk permit vlan
Use the port trunk permit vlan command to add a trunk port to one VLAN, a selection of VLANs, or all
VLANs.
Ethernet Port view
primary accounting
Use the primary accounting command to set the IP address and port number for the primary accounting
server.
RADIUS Scheme view