Filter
Top Products
3Com Switch 4200G Family 3
Command Reference
acl
Use the acl command to define an ACL identified by a number, and enter the corresponding ACL View.
System view
Web command: Device -> ACL
Security -> IP
active region-configuration
Use the active region-configuration command to activate the settings of an MST (multiple spanning
tree) region.
MST Region view
add-member
Use the add-member command to add a candidate device to a cluster.
Cluster view
address-check
Use the address-check command to enable or disable DHCP relay security on a VLAN interface, so as to
start or stop the validity check on user addresses under the VLAN interface.
VLAN Interface view
administrator-address
Use the administrator-address command to store the MAC address of the management device on a
member device.
Cluster view
Web command: Port -> Statistics
am user-bind
Use the am user-bind command to bind the MAC and IP addresses of a legal user to a specified port.
System view
Ethernet Port view
apply qos-profile
Use the apply qos-profile command to manually apply the QoS profile to the current port.
Ethernet Port view
Web command: Device -> ACL/QoS -> Profile
apply qos-profile interface
Use the apply qos-profile interface command to manually apply a QoS profile to one or more
consecutive ports.
System view
arp check enable
Use the arp check enable command to enable the ARP entry checking function, that is, to disable a switch
from creating multicast MAC address ARP entries for MAC addresses learned.
System view
arp static
Use the arp static command to configure the static ARP mapping entries in the ARP mapping table.
System view
arp timer aging
Use the arp timer aging command to configure the aging time for dynamic ARP mapping entries.
System view
ascii
Use the ascii command to configure data transmission mode as ASCII mode.
FTP Client view
attribute
Use the attribute command to configure attributes of a user whose service type is lan-access.
Local User view
Web command: Administration -> System
authentication
Use the authentication command to configure an authentication scheme for the current ISP domain.
ISP Domain view
authentication-mode
Use the command authentication-mode to specify the authentication mode.
User Interface view
authorization
Use the authorization none command to allow users in the current ISP domain to use network services
without being authorized.
ISP Domain view