3Com 10014917 Switch User Manual


 
38 3Com Switch 4200G Family
Command Reference
stp interface cost
Use the stp interface cost command to set the path cost of specified ports in a specified spanning tree
instance.
System view
stp interface edged-port
Use the stp interface edged-port command to configure the specified Ethernet ports to be either edge
ports or non-edge ports.
System view
stp interface loop protection
Use the stp interface loop-protection command to enable the loop prevention function.
System view
stp interface mcheck
Use the stp interface mcheck command to perform the mCheck operation for specified ports.
System view
stp interface no-agreement-check
Use the stp interface no-agreement-check command to enable the rapid transition feature on a specified
port.
System view
stp interface point-to-point
Use the stp interface point-to-point command to specify whether the specified Ethernet ports are
point-to-point links.
System view
stp interface port priority
Use the stp interface port priority command to set the port priority of specified ports in a spanning
tree instance.
System view
stp interface root-protection
Use the stp interface root-protection command to enable the root protection function for specified
ports.
System view
stp interface transmit-limit
Use the stp interface transmit-limit command to set the maximum number of BPDUs that each
specified port can send within a Hello time interval.
System view
stp loop-protection
Use the stp loop-protection command to enable the loop prevention function for the current port.
Ethernet Port view
stp max-hops
Use the stp max-hops command to set the maximum hop count of the MST region to which the switch
belongs.
System view
stp mcheck
Use the stp mcheck command to perform the mCheck operation for the current port.
Ethernet Port view
System view
stp mode
Use the stp mode command to set the MSTP operation mode of the switch.
System view
Web command: Device -> Spanning Tree
stp no-agreement-check
Use the stp no-agreement-check command to enable the rapid transition feature on the current port.
Ethernet Port view
stp pathcost-standard
Use the stp pathcost-standard command to set the standard used for calculating the default path costs
of ports.
System view
stp point-to-point
Use the stp point-to-point command to specify whether the port must connect to point-to-point link.
Ethernet Port view