Filter
Top Products
Community Table (IP & LE)
The Community table defines which SNMP stations in the network can access
information from the 6416SW, and which station(s) will receive a trap from the 6416SW
when the detects an error.
To create an entry in the Community table, you use the SET COMMUNITY command.
For example, the following command specifies that a community name called ATMMGMT
with an IP address of 195.44.45.244 has read-write access to the 6416SW:
ONcoreATM> set community ATMMGMT 195.44.45.244 read_write [ENTER]
The community name parameter is case-sensitive. Be sure, therefore, to enter the
community name in uppercase or lowercase letters exactly as you want it to appear. To
display a list of existing community names, use the SHOW COMMUNITY command.
Alerts (IP & LE)
To enable or disable the function for sending alerts via SNMP traps to the 6416SW
local console and network management stations, you use the SET ALERT command.
See the
ONcore Switching Hub/CELLplex 4000 ATM Command Reference Guide
. for
information on the different types of alerts you can enable and disable with this
command.
For example, the following command enables an alert to be sent when a configuration
change is made to the hub:
ONcoreATM> set alert change trap [ENTER]
5-22 ONcore ATM Switch/Control Module: Installation and User's Guide