Filter
Top Products
ONcore LEC Cannot Initialize to the LES/BUS
Use the SHOW DEVICE command and look at the subnet lan emulation status
message:
Abnormal Termination: LES connection cleared. ATM Forum cause
xx:
The LEC automatically tries to reconnect to the LES/BUS when the connection is lost. It
will try to reconnect every 5 seconds, 5 times, and thereafter every 1 minute.
Cause Code: 1
Explanation: A wrong LES address was entered using the SET DEVICE
LAN_EMULATION_CLIENT command (les_atm_address parameter), or the port
attached to the LES is not in service.
Steps to Take:
1. Check is the port status is UP-OKAY (via the SHOW PORT command), then check
that the LES ATM address is exactly the same as the one entered in the ONcore.
Cause Code: 3
Steps to Take:
If the LE server is in the same cluster (SSI links):
1. An SSI port has not enough bandwidth. Having several SSI ports on the
module may reach the bandwidth limit. Spread the SSI ports over several
modules.
2. The ATM address of an ONcore hub located on the PING path has been
changed.
Disable the SSI link and re-enable it.
If the above does not solve the problem, take a TRS dump (with the DUMP TRS
command), and contact your 3Com representative.
7-31