Filter
Top Products
46 CHAPTER 3: CONFIGURING THE BRIDGE
Restoring a
Configuration
If you have stored a backup configuration on your computer, you can
restore the configuration as follows:
1 Under Tools, click Restore Wireless Workgroup Bridge.
2 In the next page, click Browse and select the backup file to upload.
3 Click Restore.
The configuration is restored and activated on the Bridge. This operation
may cause the Bridge to reboot.
If the Bridge was using an IP address setting other than the backup,
restoring the configuration will change the IP address. If you want to
continue configuring the Bridge, do the following:
1 Close your browser.
2 Return to the 3Com Wireless Infrastructure Device Manager and click Refresh.
3 Select the device and click Configure to start a new configuration session.
Logging Out To log out of the Configuration Management System, click Logout under
Tools.
Clearing the Ethernet
Client List
The Bridge supports up to 16 specific clients (for example, computers and
printers) and keeps track of the clients with a list of their MAC addresses.
After the client limit is reached, you must clear the client list to allow a
new client to associate with the network. For example, in a hub
configuration with 16 clients connected, if you disconnect a desktop
computer and connect a new laptop in its place, you must clear the client
list to establish network association for the laptop.
To clear the Ethernet Client List:
1 Disconnect a client by unplugging its Ethernet cable from the hub or the
Bridge.
2 Launch the Configuration Management System.
3 Under System Status, click Ethernet Client List.
4 In the Ethernet Client List page, click Clear Client List.
The Bridge erases the client list. Clients that remain connected to the Bridge
are added to the list automatically when they next interact with the network.
5 Connect the new client by plugging its Ethernet cable into the hub or the
Bridge.