Filter
Top Products
Prepare for hardware installation
1-2 ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07
CNX System Administrator Guide
Prepare for hardware installation
What you need for a single installation
• One Aastra CNX unit
• One AC power cable
• One CompactFlash memory card
• One set of rack mounting brackets with six (6) Phillips head screws
• Truss head screws (not provided)
• One to four RJ-48C T1/E1 cable(s) (not provided)
• One 9-pin male DB-9 to female DB-9, RS-232 serial cable
• One or two RJ-45 10/100BaseT Ethernet cable(s) (not provided)
• (Optional) One 9-pin male DB-9 to female DB-25, RS-232 serial cable for
modem connections (not provided)
Tools required for rackmount installations
In addition to the parts listed above, the following tools are also required when
installing an Aastra CNX rackmount unit:
• #2 Phillips screwdriver
• Torque wrench
• Nutdriver set
Note: T1/E1 Ports 1, 2, 3, and 4 are available for the 30, 60, and 120 port
units.
1