Filter
Top Products
Connect the network cables
ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07 1-7
Aastra CNX Installation and Setup Procedures
Connect the network cables
Procedure
To connect the network cables:
Illustration
Note: Make sure you have the appropriate network cables that you need
for your facility. Connect them to the applicable interfaces on the rear of
the Aastra CNX as described in the following procedure.
Step Action
a Connect RJ-48C T1/E1 cable(s) to the RJ-48C T1/E1 port(s) on the rear panel of
the Aastra CNX as shown in the illustration below.
b Connect the RJ-45 Ethernet UTP cable(s) to the RJ-45 10/100 ENET port(s) on
the rear panel of the Aastra CNX as shown in the illustration below.
Ethernet RJ-45
connectors
T1/E1 RJ-48C
connectors
CONSOLE
10/100 ENET
RESET
T1 / E1
1
2
4
3
2
1
100-240
VAC
1.0A
47-63HZ
4