Filter
Top Products
Configure the network settings
ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07 1-17
Aastra CNX Installation and Setup Procedures
15 Enter “y” if the date and time are correct, and press <Enter>.
Enter “n” if the date and time are incorrect, and press <Enter>.
Note: If you entered “n” at the verification prompt, repeat step 14 to correct the date and time, and
then enter “y” at step 15.
The following message displays (after entering “y” at the verification prompt):
Configuring Network Time Protocol (NTP)...
You can configure up to 4 NTP servers. To remove an existing
server, set it's address to 0.0.0.0. If no valid servers are
given then ntp will be disabled.
Do you want to continue (y/n) [n]:
16 Enter “y” to continue, and press <Enter>.
The following prompts display:
NTP Server #1: [pool.ntp.org]:
NTP Server #2: [pool.ntp.org]:
NTP Server #3: [pool.ntp.org]:
NTP Server #4: [pool.ntp.org]:
(continued)
Step Action