Filter
Top Products
2-12
CheetahSwitch Workgroup-4508
Configuring Community Names
The following figure and table describe how to configure the community strings
authorized for trap management access. All community strings used for IP Trap
Managers must be listed in this table. Up to 5 community names may be entered.
CheetahSwitch Workgroup - 4508
SNMP Configuration: SNMP Communities
Community Name Access Status
1. public READ ONLY ENABLED
2. private READ/WRITE ENABLED
3.
4.
5.
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move. other keys to make changes.
Parameter Description
Community Name A community entry authorized for trap management access. (The maximum
string length is 20 characters).
Access Management access is restricted to Read Only or Read/Write.
Status Sets administrative status of entry to enabled or disabled.
Note: This switch has default community strings of “public” with read only access and “private” with
read/write access.
Configuring IP Trap Managers
The following figure and table describe how to specify management stations that
will receive authentication failure messages or other trap messages from the
switch. Note that all community strings used for IP Trap Managers must be listed
in the SNMP Communities table. Up to 5 trap managers may be entered.
CheetahSwitch Workgroup - 4508
SNMP Configuration: IP Trap Managers
IP Address Community Name Status
1. 10.1.0.23 public DISABLED
2.
3.
4.
5.
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move, other keys to make changes.