Filter
Top Products
2-26
CheetahSwitch Workgroup-4508
Configuring Bridge MIB Extensions
The Bridge MIB includes extensions for managed devices that support Traffic
Classes, Multicast Filtering and Virtual LANs. To configure these extensions, use
the Extended Bridge Configuration screen as shown below:
Cheetahswitch Workgroup - 4508
Extended Bridge Configuration
Bridge Capability : (Read Only)
Extended Multicast Filtering Services : NO
Traffic Classes : YES
Static Entry Individual Port : YES
VLAN Learning : IVL
Configurable PVID Tagging : YES
Local VLAN Capable : NO
Bridge Settings :
Traffic Class : FALSE
GMRP : DISABLED
GVRP : DISABLED
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move. <Space> to scroll option.
Parameter Description
Bridge Capability
Extended Multicast Filtering This switch does not support filtering of individual multicast
Services addresses based on GMRP (GARP Multicast Registration Protocol).
Traffic Classes This switch provides the mapping of user priorities to multiple traffic
classes. (Refer to 802.1P Configuration.)
Static Entry Individual Port This switch allows static filtering for unicast and multicast addresses.
(Refer to Network Monitor Menu / Static Unicast Address Table
Configuration and Static Multicast Address Table Configuration.)
VLAN Learning This switch uses Independent VLAN Learning (IVL), whereby each
port maintains its own VLAN filtering database.
Configurable PVID Tagging This switch allows you to override the default PVID setting (Port
VLAN ID used in frame tags) and its egress status (VLAN-Tagged or
Untagged) on each port. (Refer to 802.1Q VLAN Port Configuration.)
Local VLAN Capable This switch does not support multiple local bridges (that is, multiple
Spanning Trees).
Bridge Settings
Traffic Class Multiple traffic classes are supported by this switch as indicated
under Bridge Capabilities. However, the switch supports just two
priority queues and only the default port priority can be configured.
The switch does not support the configuration of traffic class
mapping. Therefore, this parameter under Bridge Settings is set to
False and cannot be enabled.
Note: This switch does not support GVRP or GMRP. Therefore, the GVRP and GMRP parameters are
always disabled.