Filter
Top Products
2-30
CheetahSwitch Workgroup-4508
802.1Q VLAN Current Table Information
This screen shows the current port members of each VLAN and whether or not
the port supports VLAN tagging. Ports assigned to a large VLAN group that
crosses several switches should use VLAN tagging. However, if you just want to
create a small port-based VLAN for one or two switches, you can assign ports to
the same untagged VLAN. The current configuration is shown in the following
screen.
CheetahSwitch Workgroup - 4508
802.1Q VLAN Current Table Information
Deleted VLAN Entry Counts : 0
VID Creation Time Status
-------------------------------------------------------
1 0 (0 day 0 hr 0 min 0 sec) Permanent
Current Egress Ports Current Untagged Ports
00000000 11111111
Sorted by VID : 1
[Show] [More]
<OK>
Use <TAB> or arrow keys to move. <Enter> to select.
Parameter Description
Deleted VLAN Entry Counts The number of times a VLAN entry has been deleted from this table.
VID The ID for the VLAN currently displayed.
Creation Time The value of sysUpTime (System Up Time) when this VLAN was
created.
Status Shows that this VLAN was added to the switch as a static entry.
Current Egress Ports Shows the ports which have been added to the displayed VLAN
group, where “1” indicates that a port is a member and “0” that it is
not.
Current Untagged Ports If a port has been added to the displayed VLAN (see Current Egress
Ports), its entry in this field will be “1” if the port is untagged or “0” if
tagged.
Sorted by VID The VID number where the table display starts.
[Show] Displays the members for the VLAN indicated by the “Sorted by VID”
field.
[More] Displays any subsequent VLANs if configured.