Filter
Top Products
Management Guide
2-39
Configuring Static Unicast Addresses
Use the Static Unicast Address Table Configuration screen to manually configure
host MAC addresses in the unicast table. You can use this screen to associate a
MAC address with a specific VLAN ID and switch port as shown below.
CheetahSwitch Workgroup - 4508
Static Unicast Addreeess Table Configuration
VID MAC Address Port Status
------------------------------------------------------------
1 00-00-00-E8-43-12 1 Permanent
Sorted by : VID + MAC VID : 1 MAC : 00-00-00-00-00-00
VID:1 Port:1
MAC : 00-00-00-00-00-00 Status : Permanent
[Show] [More] [Set]
<OK>
Use <TAB> or arrow keys to move, <Enter> to select.
Parameter Description
VID The VLAN group this port is assigned to.
MAC Address The MAC address of a host device attached to this switch.
Port The port the host device is attached to.
Status The status for an entry can be set to:
Permanent: This entry is currently in use and will remain so after the
next reset of the switch.
DeleteOnReset: This entry is currently in use and will remain so until
the next reset.
Invalid: Removes the corresponding entry.
DeleteOnTimeOut: This entry is currently in use and will remain so
until it is aged out. (Refer to Address Table Aging Time.)
Other: This entry is currently in use but the conditions under which it
will remain so differ from the preceding values.
[Show] Displays the static address table sorted on VID as the primary key
and MAC address as secondary key.
[More] Scrolls through entries in the static address table.
[Set] Adds the specified entry to the static address table, such as shown in
the following example:
VID : 1 MAC : 00-00-00-e8-34-22
Port : 1 Status : Permanent