Filter
Top Products
A-2
CheetahSwitch Workgroup-4508
(c)Copyright 2000, Accton Inc.
CheetahSwitch Workgroup-4508
LOADER Version V01.00.01
POST Version V01.00.01
------ Performing the Power-On Self Test (POST) ------
EPROM Checksum Test ....................... PASS
Testing the System SDRAM .................. PASS
CPU Self Test ............................. PASS
EEPROM Checksum Test ...................... PASS
SEEPROM Checksum Test ..................... PASS
MAC Address ..............00-e0-29-52-28-00
------------ Power-On Self Test Completed ------------
(D)ownload System Image or (S)tart Application: [S]
Select the Firmware Type to Download (1)Runtime (2)POST (3)Mainboard
[1]:
For example, if you select 1 (for downloading agent firmware), the system will
display the following message:
(D)ownload System Image or (S)tart Application: [S]
Select the Firmware Type to Download (1)Runtime (2)POST
(3)Mainboard [1]: 1
Your Selection: Runtime Code
Download code to FlashROM address 0x02880000
Change Baud Rate to 115200 and Press <ENTER> to Download.
3. Change your baud rate to 115200 bps, and press Enter to enable download
mode. From the terminal emulation program, select the file you want to
download, set the protocol to XModem, and then initialize downloading.
Notes: If you use Windows HyperTerminal, disconnect and reconnect to
enable the new baud rate.
The download file should be an ES4508 binary file from Accton; otherwise
the agent will not accept it. The file naming convention is:
Runtime program: Agent-Vx.yz,
POST program: Boot-Vx.yx, and
Mainboard program: 8051-Vx.yz
4. After the file has been downloaded, the console screen will display
information similar to that shown below. Press “s” to start the management
interface, change the baudrate back to 19200, and press Enter. The Logon
screen will then appear
XModem Download to DRAM buffer area 0x00200000: ... SUCCESS !
Verifying image in DRAM download buffer 0x00200000... SUCCESS !
Update FlashROM Image at 0x02880000 ... SUCCESS !
(D)ownload another Image or (S)tart Application: [S] s
Change Baud Rate to 19200 and Press <ENTER>.
For details on managing the switch, refer to Chapter 2 for information on the
out-of-band console interface, or Chapter 3 for information on the Web
interface.