Filter
Top Products
Management Guide
3-9
SNMP Community
The following figure and table describe how to configure the community strings
authorized for trap management access. All community strings used for IP Trap
Managers must be listed in this table. Up to 5 community names may be entered.
Parameter Description
Community String A community entry authorized for trap management access. (The maximum
string length is 20 characters).
Access Mode Management access is restricted to Read Only or Read/Write.
Add/Remove Add/remove strings from the active list.
Trap Managers
The following figure and table describe how to specify management stations that
will receive authentication failure messages or other trap messages from the
switch. Note that all community strings used for IP Trap Managers must be listed
in the SNMP Communities table. Up to 5 trap managers may be entered.
Parameter Description
Trap Manager IP Address IP address of the trap manager.
Trap Manager Community String A community specified in the SNMP Communities table.
Add/Remove Add/remove strings from the active list.
Enable Authentication Traps Issues a trap message to specified IP trap managers whenever
authentication of an SNMP request fails. (The default is enabled.)