Filter
Top Products
5 Troubleshooting
128
• Make sure the FDD and signal cables are properly connected.
• Check that relevant switches and jumpers for the FDD are set
correctly.
• Check that FDD is properly configured.
• If you are using the onboard diskette controller, use BIOS setup on
page 81 to make sure that onboard “Floppy A” is set to 1.44 MB,
3.5-inch.
HDD activity indicator does not light.
If you have installed one or more hard drives in your system, do the
following:
• Make sure the power and signal cables are connected correctly.
• Check that relevant switches and jumpers on the hard drive and
SCSI or SATA backplane are set correctly.
CD drive activity indicator does not light.
Do the following:
• Make sure the power and signal cables are properly installed.
• Check that relevant switched and jumpers on the drive are set
correctly.
• Check that drive is properly configured.
• Check that onboard IDE controller is enabled in the BIOS setup.
CD tray cannot be ejected.
Do the following:
• Insert the tip of a paperclip into the small hole on the CD drive.
Slowly pull the tray out from the drive until the tray is fully
extended then remove the disc.