Filter
Top Products
Machine Maintenance Procedures 3-15
WLAN (Wireless Local Area Network) Module Removal 0
Prerequisite:
Base Door Removal
1. Locate module (D) on lower cover. Refer to Figure 3-6.
2. Disconnect main (A) and auxiliary (B) antenna cables from module as shown in
Figure 3-9.
3. Remove screw (C) (M2.5*2.3) from mainboard.
4. Remove module from mainboard connector (D).
Figure 3-9. WLAN Module
NOTE:
NOTE
:
Main (black) antenna connector is close to ODD module. Auxiliary (white) antenna
connector is close to battery bay.
WLAN Module Installation 0
1. Insert module into mainboard connector (D). Refer to Figure 3-9.
2. Install and secure screw (C) (M2.5*2.3) to mainboard.
3. Install main (A) and auxiliary (B) antenna cables on WLAN module.
4. Install base door.
A
A
B
B
C
D
D