Filter
Top Products
3-34 Machine Maintenance Procedures
Fingerprint Module Removal 0
Prerequisite:
Upper Cover Removal
1. Locate fingerprint module (E) on upper cover. Refer to Figure 3-25.
2. Disconnect module FFC (A) from module connector (B) as shown in Figure 3-30.
3. Remove module FFC (A) from upper cover.
4. Remove screw (C) (M2.0*3.0-I) from upper cover.
5. Remove module bracket (D) from upper cover.
6. Remove module from upper cover.
Figure 3-30. Fingerprint Module
Finger Print Module Installation 0
1. Install module on upper cover.
2. Install module bracket (D) and align with screw hole. Refer to Figure 3-30.
3. Install and secure screw (C) (M2.0*3.0-I) to upper cover.
4. Install module FFC (A) on upper cover.
5. Connect module FFC (A) to module connector (B).
6. Install upper cover.
A
A
B
B
D
D
C