Filter
Top Products
Machine Maintenance Procedures 3-39
6. Flip mainboard over as shown in Figure 3-35.
7. Disconnect cable from mainboard connector (A).
Figure 3-35. Mainboard Connectors (Bottom)
8. Flip mainboard over as shown in Figure 3-36.
9. Remove two (2) screws (A) (M2.5*6.0-I) from lower cover.
Figure 3-36. Mainboard in Lower Cover
NOTE:
NOTE
:
Connectors on left side of mainboard (i.e. USB 3.0, HDMI, etc.) are set in lower cover
slots. Do not force mainboard when trying to remove it.
10. Lift right side (B) of mainboard until edge is a few cm above lower cover.
A
A
C
C
B
B
A
A