Filter
Top Products
Machine Maintenance Procedures 3-37
USB Module Removal 0
Prerequisite:
Upper Cover Removal
1. Locate USB module (B) on lower cover as shown on Figure 3-31.
2. Disconnect module FFC (A) from module connector (B). Refer to Figure 3-33.
3. Disconnect module FFC (A) from mainboard connector (C).
Figure 3-33. USB Module
NOTE:
NOTE
:
The USB module FFC is part of the lower cover FRU (Field Replacement Unit)
component. Do not remove it.
4. Remove screw (D) (M2.5*6.0-I) from lower cover.
5. Remove module from lower cover.
USB Module Installation 0
1. Install module (B) on lower cover. Refer to Figure 3-31.
2. Connect module FFC (A) to module connector (B). Refer to Figure 3-33.
3. Connect module FFC (A) to mainboard connector (C).
4. Install and secure screw (D) (M2.5*6.0-I) to lower cover.
5. Install upper cover.
A
A
B
B
C
C
C
C
D