Filter
Top Products
Chapter 4 77
Index of Error Messages
Error Code List
Error Codes Error Messages
006 Equipment Configuration Error
Causes:
1. CPU BIOS Update Code Mismatch
2. IDE Primary Channel Master Drive Error
3. IDE Secondary Channel Master Drive Error
010 Memory Error at XXXX:XXXX:XXXXh (R:XXXXh, W:XXXXh)
070 Real Time Clock Error
071 CMOS Battery Bad
072 CMOS Checksum Error
110 Incorrect password specified, system disabled. (Text mode only)
<No Error Code> Battery critical low
In this situation, BIOS will issue 4 short beeps that shut down the
system. No message will be shown.
<No Error Code> Thermal critical high
In this situation, BIOS will issue 3 long beeps then shut down the
system.
Error Message List
Error Messages FRU/Action in Sequence
Failure Fixed Disk Reconnect hard disk drive connector.
“Load Default Settings” in BIOS Setup Utility.
Hard disk drive
System board
Stuck Key see “Keyboard or Auxiliary Input Device Check” on page 73 .
Keyboard error see “Keyboard or Auxiliary Input Device Check” on page 73.
Keyboard Controller Failed see “Keyboard or Auxiliary Input Device Check” on page 73.
Keyboard locked - Unlock key switch Unlock external keyboard
Monitor type does not match CMOS - Run Setup Run “Load Default Settings” in BIOS Setup Utility.
Shadow RAM Failed at offset: nnnn BIOS ROM
System board
System RAM Failed at offset: nnnn DIMM
System board
Extended RAM Failed at offset: nnnn DIMM
System board
System battery is dead - Replace and run Setup Replace RTC battery and Run BIOS Setup Utility to reconfigure
system time, then reboot system.
System CMOS checksum bad - Default
configuration used
RTC battery
Run BIOS Setup Utility to reconfigure system time, then reboot
system.
System timer error RTC battery
Run BIOS Setup Utility to reconfigure system time, then reboot
system.
System board