Filter
Top Products
Section 5, User Interface - Menu Descriptions
61179605L5-5B 5-73
SHDSL Loop 1 Interface Mode Menu
The SHDSL Loop 1 Interface Mode menu (see Figure 5-53) is used to set the interface mode.
The interface mode can be set to either 2-wire or 4-wire. SHDSL transceivers are designed
primarily for duplex operation over mixed gauge 2-wire twisted metallic pairs, however,
optional 4-wire operation is supported for extended reach applications.
Figure 5-53. SHDSL Loop 1 Interface Mode Menu
The SHDSL Loop 1 Interface Mode menu options are shown in Table 5-53.
NOTE
The line rate on both pairs must be the same.
Table 5-53. SHDSL Loop 1 Interface Mode Menu Options
Option Description Function
1 2-wire
This option sets the interface mode to single-pair
operation. SHDSL offers rates from 192 kbps to 2.3
Mbps in increments of 64 kbps.
2 4-wire
This option sets the interface mode to dual-pair
operation. SHDSL offers rates from 384 kbps to 4.6
Mbps in increments of 64 kbps.
09/01/05 03:59
Total Access 1240
SHDSL Loop 1 Interface Mode
1. 2-wire
2. 4-wire
Selection:
'?' - System Help