Filter
Top Products
27
Open/save data
MAIN MENU FUNCTION
Language selection operating language
Load/store data load and store data
Set points/characteristics set point processing
Parameter display and modification of parameters
Operation display select operation display
Last function energy and operating hours
TAB. 6 LBA MAIN MENU
3.1.3 LBA SUBMENUS
The first six lines of the above main menu contain the names of the sub-menus. These are shown
below, with explanations, in the sequence they are contained in the menu.
= Main menu (appears after plugging in the LBA)
Set points/curve
Sprache/language
Menu
Submenu
next
submenu
Default
Value
User
Value
Remarks
Parameters
Sprache/language
Deutsch x
English
Francais
Open/save data Loading, storing, copying of parameter sets
Thyro-P -> LBA 1
LBA -> Thyro-P 2 Parameter from LBA-EEPROM to Thyro-P RAM
Store in LBA Parameter from LBA-RAM to LBA-EEPROM
Save Thyro-P Parameter from Thyro-P RAM to Thyro-P EEPROM
1 Open data again
Thyro-P -> LBA Store parameters from Thyro-P in LBA
waiting time
Observe waiting time! OK key during charging releases
the parameter lock
ASIC-SW Shows production date of controller software
Code LBA Shows version of LBA software
2 Save data again
LBA -> Thyro-P Store parameters from LBA in Thyro-P
waiting time Observe waiting time!
Set points/curve Remark: Display is refreshed after max. 10 sec.
motor pot. 0 Display and modification set point 4
Term. (10) Display set point 1
Term. (11) Display set point 2
Master(bus) Display set point 3 (bus)
Act.pwr.tot:xx,xxmA
Display total set point
Absolute set points
During active circuit set point is displayed
in a submenue depending on control mode
STD,LOC,REMOTE,ANA STD Choice of set point inputs
ADD,IADD, PRO,IPRO ADD
SW1+SW2, SW1-SW2, SW1*SW2%/100%, SW1*(1-SW2%/100%)
5V,10V,mA term(10) mA Selection signal type for set point 1*
5V,10V,mA term(11) 5V Selection signal type for set point 2*
Ctrl.start1 4.00mA 0.3mA Control start set point SW1
Ctrl.end1 20.00mA 20.0mA Control start set point SW1
Ctrl.start2 20.00V 0.07V Control start set point SW2
Ctrl.end2 10.00V 5.0V Control end set point SW2
* refer to ”ATTENTION” on page 16
Adress
Bus+LL-compound xxx
100 xxx for fibre optic 001 - 998
in case of Profibus DP 001 - 125
000 and 999 have specific functions
Main menu