Filter
Top Products
29
Remarks
Parameters
Main menu
= Main menu (appears after plugging in the LBA)
Submenu
Menu
next
submenu
Default
Value
User
Value
XR
YR
XA
YA
Operating mode
TAKT/FC TAKT
Operating mode selection full oscillation clock principle
VAR /PA Operating mode selection phase-angle principle
SSSD/FC-PA Operating mode selection Soft-Start-Soft-Down
Res Reserve
No.ctrld.phase 123 1 Number of phases controlled (power paths)
Load R,RL,transf.,C
R: without startup ramps, C: like R, only for TAKT
Service OFF,ON OFF Operation without controls or limitations
ASM OFF, ON, OFF OFF Display for ASM process
Uses analog output 2, terminal 33
MoSi OFF,R,S OFF R: ramp, S: steer
Afterpulse OFF,ON ON Only for 3-phase and VAR
TDS OFF,ON OFF Only for 3-phase and VAR
Neutral OFF,ON OFF Only for 3-phase
Hardware parameters
Curr.conv. xxxxx 100 Transformation ratio ü:1
Volt.conv. xxxx 16 Transformation ratio ü:1
X501-3 1-2,2-3,3-4
Voltage adjustment measurement range 3 see chapter
Voltage transformer
Type current xxxxx type See name plate
Type voltage xxxx type See name plate
Burden load. xxx,xx 1 Ohm current transformer adjustment incl. tolerances
Frequency Only display of the mains frequency
Date yyyymmdd Input and display
Time hhmmss Input and display
Cntr. data log. x Current count of data logger counter 1 to 16
Peak value xxxxx 65000
Peak current value at which instant impulse lock
shall be set (in Ampere)
SW_FA_1-6 *
list_L1-3_FA *
DAC1-3_FA *
TI_FA *
KP_FA *
Puls.s.off OFF,ON ON
IMAB: shutdown of the Power Controller in case of fault
K1 closed-c OFF,ON * ON
K1RU: switching open contact/closed contact (only K1)
Monitoring Display/setting of the monitoring values
Relative/Absolute R/A
Undercurrent OFF/ON x
Overcurrent OFF/ON y
Monit. L2 OFF/ON
Monit. L3 OFF/ON
U
line
max
xxxV
1)
absolute limiting value, see Fig. 4
U
line
max
xxxV
1)
absolute limiting value, see Fig. 4
Temperature 6
1)
change of absolute limiting value is only possible if
Messages 7
the corresponding relative limiting value are zero/255.
2)
change of absolute limiting value is only possible if
the corresponding relative limiting value are zero/5000.
Monitoring Relativ
Undercurrent xx % Cursor is in front of the selected value
Overcurrent xx %
Value unequal
ZERO!
Monitoring absolut
Undercurrent xx A Cursor is in front of the selected value
Overcurrent xxx A
ZERO!
* password protection