Filter
Top Products
37
EVENT NO. PRESET STATUS MESSAGE
LOG RELAY
1 Communication RS 232 interface active
2 Communication fi bre optic interface active
3 Negative power (calculated value)
4 Communication fault RS 232 or fi bre optic interface
5 Synchronous interface fault (for instance Profi bus)
6 External processor on the SSC signals fault
7 K3 after RESET - monofl op function
8 Controller lock is active
9 Data in the EEPROM invalid
(then reload Thyro-P parameter memory using
Thyro-Tool Familiy)
10 Internal message
11 K2 Limiting exceeded
12 Device overtemperature
13 Quick circuit interruption has responded
14 Internal message
15 Failure in load circuit, collective failure
16 Undercurrent in load circuit, when activated
17 Overcurrent in load circuit, when activated
18 Internal message
19 DaLo Indication appears on return of supply
20 Undervoltage in the power section
21 Overvoltage in the power section
22 Internal message
23 Internal message
24 K1 Synchronization fault
25 Collective fault
(each fault leads to switching of the output)
26 Internal message
27 Internal message
28 Internal message
29 Internal message
30 For the operating mode MOSI:
Power Controller has run into peak current limitation
31 Temperature sensor, short circuit or sensor break
TAB. 10 ALLOCATION OF THE MESSAGE REGISTER