Filter
Top Products
6-10 User’s Manual
Operational
Problems
The table below contains advice on dealing with repeated paper feed
problems.
Problem Causes and solutions
Paper does not feed cleanly Top edge of paper stack may be
from paper tray deformed (wavy or bent sheets). Try
turning the paper stack around.
Paper stack may not be aligned
properly. Pull out the tray,
straighten the paper stack against the
paper guides, and re-insert the tray.
Too many sheets in the paper stack.
Make sure the stack is level with or
below the limit mark on the left
paper guide.
The paper pressure plate may not be
released. Pull out the tray and insert
the tray again until it clicks up.
Problem Solutions
No power when you turn on Check that the power cord is
the printer plugged in at both ends and that
the power outlet has power.
Printer does not initialize Close the upper door completely.
Push down (lock) the paper guide
(inside the rear stacker) in position.
Printer initializes, but does not Install a print unit.
online Insert the paper tray all the way.
Printer initializes, but the Use the control panel to select the
settings are wrong desired settings.
Operational Problems
08 Chapter 6 07.08.1997, 11:41 Uhr10