Filter
Top Products
3-6 User’s Manual
C
learing the Buffer and Reinitializing the Printer ( )
Pressing and holding down for five or more seconds clears the
print buffer and tells the printer to initialize itself. You might use
this function if you cancel a print job in the middle and want to clear
the printer and start over. In this case, permanently downloaded
fonts are removed by the initialization process. You must download
the fonts again.
Printing a Status Report ( )
The status report function prints a page that summarizes printer
option settings and shows samples of resident fonts.
To print a status report, follow these steps:
1. Make sure that the message display indicates
READY with the
ONLINE and DATA indicators off.
2. Press the
button for five or more seconds.
The message changes to
SELF TEST with the DATA indicator
flashing and the status report begins printing. After printing, the
printer returns to the original state. See Figure 3-2.
Notice:
The status report is for either the PCL emulation or the FPS
emulation depending on the emulation you used for printing the last
document; however, the status report is for the FPS emulation if it is
printed immediately after the printer is turned on. To clearly select
the report, use the test menu in setup mode. See Chapter 3.
Control Panel Functions
☞
05 Chapter 3 07.08.1997, 11:40 Uhr6