Filter
Top Products
3-18 User’s Manual
Manual timeout
Time interval to be allotted for manual insertion
Banding mode Switching printing control (band/full page)
Auto Auto mode (standard setting). Switches the
following two modes depending on the total
RAM capacity: virtual memory mode for
10MB or less (equivalent to banding mode on)
and speed mode for more than 10MB
(equivalent to banding mode off)
Off Speed mode. Attaches importance to speedup
of printing control, thus processing all pages
per job. Print density is set to 300 dpi when
total RAM capacity is 3M to 9M bytes. To
print on legal-size paper, set banding mode on,
or the total RAM capacity must be 10M bytes
or more.
On (Virtual) memory mode. Attaches importance
to reliable printing rather than speedup, thus
processing data per page.
Config menu
Personality Selecting an emulation (personality) without a
PJL command which clearly specifies the
emulation
Auto continue Automatic control of continuing recoverable
errors
I/O timeout Time interval allowed for switching the
interface
I/O buffers Size of interface buffer
NPAP area size Size of work area for NPAP (network printer
alliance protocol)
Power save Setting the time interval during which the
printer remains idle state before sleep mode
after printing last
On after 15 min Power save mode on. The printer enters sleep
On after 30 min mode after remaining idle state for ## minutes
On after 60 min after printing last.
On after 120 min
Off Power save mode off. (Even in this mode, the
printer enters sleep mode after remaining idle
state for 180 minutes.)
Menu Items
05 Chapter 3 07.08.1997, 11:40 Uhr18