Filter
Top Products
42
Chapter 2: Connecting and Configuring Hardware
To install, remove, or replace measurement modules
To install, remove, or replace measurement modules
CAUTION: Electrostatic discharge can damage electronic components. Use grounded
wrist straps and mats when performing any service to measurement modules.
NOTE: Measurement modules with different model numbers may not be connected
together in multi-card (Master/Expander) modules unless stated otherwise.
For information on specific measurement modules go to:
1 Power down the system and disconnect the power cable before
installing, removing or replacing measurement modules.
2 Remove filler panels and carefully slide the module into the frame.
3 Gently apply pressure to the center of the module while tightening the
thumb screws.
Module Type Page
Logic Analyzer 45
Oscilloscope 71
Pattern Generator 87
Power
Busy