Filter
Top Products
Download New Firmware
Xmodem Download of Firmware
112
6. Press
6
to display the XMODEM download menu shown in Figure 6-6.
Figure 6-6: Probe XMODEM Download Menu
7. Press
1
,
2
, or
3
to select the download baud rate. You receive the following
message on your PC:
Downloading to Flash: Receiving File. . .
This and all of the messages are transmitted at 9600 baud. If you selected a
different baud rate, the messages will not be displayed correctly. However,
the download will work correctly.
8. If you select a baud rate other than 9600, you will need to change the baud
rate of your terminal emulator to match the download speed that you
selected. If you are using the HyperTerminal application, select File ->
Properties -> Configure. You must
select the
Disconnect
icon followed by
the
Connect
icon to get the baud rate changes to take effect.
9. Select
Transfer
and then
Send File
menu items from your PC’s Windows
application. You will be prompted to select the file to download.
The HyperTerminal application is configured for Zmodem by default. You
need to make sure that you select Xmodem from the
Send File
dialog box.
XMODEM Download Menu -- Firmware Rev.
1. Download at 38400 baud
2. Download at 19200 baud
3. Download at 9600 baud
0. Return to previous menu