Filter
Top Products
Local Terminal Configuration
Probe Configuration Using a Local Terminal
17
Probe Configuration Using a Local Terminal
Some initial configuration information must be entered into the probe before it
can communicate over the LAN telemetry network interface or serial port. The
ATM interface must be configurated before monitoring can occur.
The initial configuration for the Ethernet LAN Telemetry network (10Base-T or
100Base-TX) communication consists of the following parameters:
IP Address
Default Gateway IP Address (if required)
Subnet Mask (if required)
Autodiscovery Echo Interval
If you are configuring the optional Token-Ring LAN Telemetry interface, you
need to configure the following parameters:
Ring Speed
Ring Number
The probe uses the following configuration parameters to display time and date
information in the user interface only. The probe uses a separate internal clock to
time-stamp data collected from the network.
Date
Time
Time Zone
The initial configuration for communication over the serial port consists of the
following parameters:
Serial Port IP Address
Serial Port Subnet Mask (if required)
Serial Port Speed
Serial Port Mode
Modem Control String (if required)