Filter
Top Products
Installation
Connecting the Probe
50
Connecting to the Network (Out-of-Band)
You can connect the probe to an Out-of-Band telemetry network as described in
one of the following topics. Figure 3-3 on page 51 shows both versions of the
probe’s rear panel with the Token-Ring option installed.
“Connecting to 10MB/s Ethernet Telemetry Networks” below
“Connecting to 10Base-T/100Base-TX Telemetry Networks” on page 52
“Connecting to Token-Ring Telemetry Networks” on page 54
CAUTION
Do not touch the probe connector pins or the cable connector pins. Static
discharge may damage equipment.