Filter
Top Products
Local Terminal Configuration
Using a Local Terminal
22
Modify/View Configuration Values
Use the following procedure to configure items in the Modify/View Configuration
Values menu:
1. Press
1
to access the
Modify/View configuration values
menu item. The
Modify/View Configuration Values menu is displayed, as shown in Figure
2-3.
Figure 2-3: Modify/View Configuration Values Menu
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network.
Autodiscovery Press
1
and enter the autodiscovery echo interval, in
Echo Interval seconds, as desired for your probe (optional). This parameter
sets the time interval for the probe to transmit an
autodiscovery frame, which is used by HP OpenView to
maintain its network map.
The default value is 30 minutes (1800 seconds). A value of
zero results in no transmission of autodiscovery frames.
Modify/View Configuration Values Menu - Firmware Rev
Memory configuration x Mbytes
1. Autodiscovery Echo Interval (sec.) 1800
2. Date Wed 05/05/97
3. Time 09:12:00
4. Time zone PST8PDT
S. Save changes and exit
0. Cancel changes and exit