Filter
Top Products
Troubleshooting QoS Troubleshooting QoS
page 10-14 OmniSwitch Troubleshooting Guide September 2005
QVID Egress VLAN ID. A value appears in this field if the packet is being
routed to the destination IP address, which is the address that appears in
the IP field.
EGR0 The egress slot/port on ASIC 0. The port that will forward a routed
packet to the destination IP address, which is the address that appears in
the IP field. EGR0 must be equal to EGR1. A -1 in this field indicates
that packets cannot be routed to the IP on this slot.
EGR1 The egress slot/port on ASIC 1. The port that will forward a routed
packet to the destination IP address, which is the address that appears in
the IP field. EGR0 must be equal to EGR1. A -1 in this field indicates
that packets cannot be routed to the IP on this slot.
IR Ignore routing. Packets to this IP are switched and not routed on this
ASIC. The value of this field is usually 1 on all ASICs, except the
ASIC where the address resides. A value of 0 on all ASICs may indi-
cate that the ARP for the IP address is not yet available.
TG Tagged, if 1 set the QVID value on the egress routed packet, if the
egress port (as indicated by EGR0 EGR1) is tagged.
BC If 1 this is an IP broadcast packet, and packets to this destination IP are
flooded out on the ports of the egress VLAN.
subnet The IP subnet.
NSR Always 255.
output definitions (continued)