Filter
Top Products
page -14 OmniSwitch Troubleshooting Guide September 2005
protocol Specifies a protocol type to debug. Specify tcp to debug TCP packets;
specify udp to debug UPD packets; specify icmp to debug ICMP pack-
ets; specify igmp to debug IGMP packets; specify num to numerically
specify a protocol (e.g., 89); specify all to debug all protocol types.
show-broadcast Specifies whether or not to display broadcast packets. Specify on to
display broadcast packets on the screen or in the log; specify off if you
do not want to display broadcast packets.
show-multicast Specifies whether or not to display multicast packets. Specify on to
display multicast packets on the screen or in the log; specify off if you
do not want to display multicast packets.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• If you use the basic command to start debug (debug ip packet start) the switch will use default param-
eters for all of the debug options. Once you configure one of the optional parameters, the switch will
use the new parameter(s) until changed.
• If you do not specify a timeout value, the session will continue until it is stopped.
• You must enter the start keyword to begin debugging.
• The command debug ip packet without the start keyword displays IP debug configuration parameters.
Examples
-> debug ip packet start timeout 1
Release History
Release 5.1; command was introduced.
parameter default
timeout -1
in | out | all all
header | text | all header
console | file console
cmm | ni | all | none all
arp | ip | hex | all all
tcp | udp | icmp | igmp | num | all all
on | off on
on | off on