Filter
Top Products
Troubleshooting Server Load Balancing Troubleshooting Commands
OmniSwitch Troubleshooting Guide September 2005 page 17-3
Troubleshooting Commands
Below is a list of commands, which will be used and discussed in this chapter.
show ip slb (Displays SLB information)
show ip slb cluster-name
For example:
-> show ip slb cluster Intranet
Cluster Intranet
VIP : 128.241.130.205,
Admin status : Enabled,
Operational status : In Service,
Routed flows success ratio (%) = 100,
Ping period (seconds) = 60,
Ping timeout (milliseconds) = 3000,
Ping retries = 3,
Redirect algorithm : round robin,
Sticky time (seconds) = 600,
Number of flows = 45768,
Number of servers = 2
Server 128.220.40.4
Admin status = Enabled, Operational Status = In Service,
Weight = 10, Number of flows = 2000, Availability (%) = 98
Server 128.220.40.5
Admin status = Enabled, Operational Status = Discovery,
Weight = 10, Number of flows = 0, Availability (%) = 0
ip slb admin {enable | disable} (Enables or disables the SLB service)
ip slb cluster cluster-name admin status {enable | disable}
ip slb cluster cluster-name distribution {round robin | server failover}
[no] ip slb server ip
ip-address
For example:
-> show ip slb
Admin status : Enabled,
Operational status : In Service,
Number of clusters = 3
Viewing data of all clusters:
show ip slb clusters
For example:
-> show ip slb clusters
Admin Operational # %
Cluster Name VIP Status Status Srv Avail
----------------+----------------+--------+-------------------+-----+---------
WorldWideWeb 128.241.130.204 Enabled In Service 3 95
Intranet 128.241.130.205 Enabled In Service 2 100
FileTransfer 128.241.130.206 Enabled Out of Service 2 50